In Box Review of RPM 1/35 Scale
Sd.Kfz. 135 s.W.D. 40/32cm ROCKET LAUNCHER
"STUKA ZU FUSS" (EX-LORRAINE L37L)
Copyright 1998
Available at Hobbylink Japan for 5520 yen ($51.70)
KIT NO. 35050
By Ray Mehlberger
Available at Hobbylink Japan for 5520 yen ($51.70)
KIT NO. 35050
By Ray Mehlberger
HISTORY:
The Lorraine was a French infantry carrier. In the early 1930s the French army required a replacement for their existing Renault UE light infantry carriers (subject of another review in this issue) and the Societe Lorraine - builders of railway stock - developed a vehicle known as the Chenillette Lorraine Type 37L.
This was a simple tracked carrier for infantry or cargo, with a two-man crew protected by small cupolas. It carried no armament. Suspension was by three twin bogies on each side, with leaf springs. A second version, the Chenillette Legere, had two twin bogies, was shorter, and was used primarily for infantry work.
Production began in 1937, but in 1939 was moved to another factory. This interrupted the production, and in consequence not many were built.
In 1940 an armoured personnel-carrying version was built, with the hull sides built up with armour at the rear to form a protected passenger compartment. After the fall of France almost all of these carriers were taken over by the German army and most were used as the basis for a variety of self-propelled guns, mounting calibres between 75-150mm (2.95-5.9in).
At the end of the war the French army modified one or two by fitting the British 17pdr. anti tank gun in the rear compartment, facing forward between the crew cupolas. The gun could not be fired while on the move and these modified vehicles were more in the nature of mobile anti-tank guns than self-propelled equipments.
Similar to the mounting of the 40/32cm rockets on the captured French Renault UE's. These same rockets were mounted on captured Lorraine's by the Germans.
The rockets were mounted on the side frames still in their carrying cases. Aiming was done by simply pointing the vehicle towards the target, and the rockets were then fired one at a time in a set sequence.
The 32cm rocket had an incendiary warhead in heavy liquid form. It had a range limitation of just over 2000m (2,188 yards) and was highly inaccurate despite their spin stabilization and were consequently used en masse whenever possible. Counterbalancing these disadvantages was the fact that they were devastating in their effects if they hit a target, and the high explosive rocket was highly regarded for use in urban fighting where houses or other structures had to be demolished.
The Lorraine was a French infantry carrier. In the early 1930s the French army required a replacement for their existing Renault UE light infantry carriers (subject of another review in this issue) and the Societe Lorraine - builders of railway stock - developed a vehicle known as the Chenillette Lorraine Type 37L.
This was a simple tracked carrier for infantry or cargo, with a two-man crew protected by small cupolas. It carried no armament. Suspension was by three twin bogies on each side, with leaf springs. A second version, the Chenillette Legere, had two twin bogies, was shorter, and was used primarily for infantry work.
Production began in 1937, but in 1939 was moved to another factory. This interrupted the production, and in consequence not many were built.
In 1940 an armoured personnel-carrying version was built, with the hull sides built up with armour at the rear to form a protected passenger compartment. After the fall of France almost all of these carriers were taken over by the German army and most were used as the basis for a variety of self-propelled guns, mounting calibres between 75-150mm (2.95-5.9in).
At the end of the war the French army modified one or two by fitting the British 17pdr. anti tank gun in the rear compartment, facing forward between the crew cupolas. The gun could not be fired while on the move and these modified vehicles were more in the nature of mobile anti-tank guns than self-propelled equipments.
Similar to the mounting of the 40/32cm rockets on the captured French Renault UE's. These same rockets were mounted on captured Lorraine's by the Germans.
The rockets were mounted on the side frames still in their carrying cases. Aiming was done by simply pointing the vehicle towards the target, and the rockets were then fired one at a time in a set sequence.
The 32cm rocket had an incendiary warhead in heavy liquid form. It had a range limitation of just over 2000m (2,188 yards) and was highly inaccurate despite their spin stabilization and were consequently used en masse whenever possible. Counterbalancing these disadvantages was the fact that they were devastating in their effects if they hit a target, and the high explosive rocket was highly regarded for use in urban fighting where houses or other structures had to be demolished.
THE KIT:
RPM is an old prolific model company based in Warsaw, Poland. They manufacture all manner of model subjects in the popular scales.
The kit comes in a shrink-wrapped tray and lid type box.
The box art shows the tank firing its rockets at night. It is in a base of tan with dark-green wave pattern camouflage. No markings are shown.
RPM is an old prolific model company based in Warsaw, Poland. They manufacture all manner of model subjects in the popular scales.
The kit comes in a shrink-wrapped tray and lid type box.
The box art shows the tank firing its rockets at night. It is in a base of tan with dark-green wave pattern camouflage. No markings are shown.
WHAT’S IN THE BOX:
The kit contains 11 trees of very pale-gray parts trees, the instructions, and two small decal sheets. None of the parts are in cello bags. The instructions consists of an unbound booklet in 11 3/4" x 8 1/2" page format of six pages.
Page one begins with a black and white repeat of the box art next to the history of the history of the vehicle in Polish only.
This is followed by a painting and marking drawing that calls out Humbrol colors. It shows a vehicle used in France in 1944. It is in a camouflage of a base of sand with green blotches. The rockets are green also. Again no markings are shown.
This drawing shows some kind of a canvas awning over the crew compartment that is not included in the kit. Too bad, it would have been a little neater if it had been.
The bottom of page 1 and the top of page 2 show the parts tree drawings. Like I said earlier, you will have to constantly refer to these to assemble the basic vehicle as they are not alphabetized.
The kit contains 11 trees of very pale-gray parts trees, the instructions, and two small decal sheets. None of the parts are in cello bags. The instructions consists of an unbound booklet in 11 3/4" x 8 1/2" page format of six pages.
Page one begins with a black and white repeat of the box art next to the history of the history of the vehicle in Polish only.
This is followed by a painting and marking drawing that calls out Humbrol colors. It shows a vehicle used in France in 1944. It is in a camouflage of a base of sand with green blotches. The rockets are green also. Again no markings are shown.
This drawing shows some kind of a canvas awning over the crew compartment that is not included in the kit. Too bad, it would have been a little neater if it had been.
The bottom of page 1 and the top of page 2 show the parts tree drawings. Like I said earlier, you will have to constantly refer to these to assemble the basic vehicle as they are not alphabetized.
Page 3 and 4.
Also at the bottom of page 1 is RPM’s street address in Warsaw, Poland and their telephone number.
The bottom of page 2 through to page 6 gives a grand total of 24 assembly steps to finish this model.
Step number 13 refers to the individual links. It has an arrow pointing at the completed runs in the drawing there with 29 x 104 as a label at the end of the arrows. Anybody know what the heck they're trying to tell us here???
The parts for the basic Lorraine vehicle have no lettered trees. Nor are there any part numbers molded onto these trees. You have to constantly refer to the parts tree drawings to identify these parts.
The bottom of page 2 through to page 6 gives a grand total of 24 assembly steps to finish this model.
Step number 13 refers to the individual links. It has an arrow pointing at the completed runs in the drawing there with 29 x 104 as a label at the end of the arrows. Anybody know what the heck they're trying to tell us here???
The parts for the basic Lorraine vehicle have no lettered trees. Nor are there any part numbers molded onto these trees. You have to constantly refer to the parts tree drawings to identify these parts.
Bad move RPM!!
The largest of these pale-gray trees holds the vehicle's top, bottom, sides, nose, transmission cover plate, crew compartment walls, vented muffler shield plate, tools, louvered engine cover etc. (35 parts here)
The largest of these pale-gray trees holds the vehicle's top, bottom, sides, nose, transmission cover plate, crew compartment walls, vented muffler shield plate, tools, louvered engine cover etc. (35 parts here)
There are two identical pale-gray trees of parts that make up the vehicle's suspension, road wheels, bogies, seat cushions, leaf springs, some body panels etc. (78 parts per tree).
The four identical pale-gray trees of parts for the basic vehicle contain the individual track links. I must say here that these are "TINY"....measuring only a scant 1/4" in width. (There are 63 links per tree) Why the odd count on these trees? It is because one link is missing on each tree and was probably miss-molded and left at the RPM factory.
From the remaining trees of parts in the kit, I get the idea that MIRAGE and RPM model companies are one in the same, or, at least they loan molds to each other. This is because the other 4 trees of parts in the kit, for the rockets and their frames and crates, are EXACTLY the same as what is in the Mirage company's kit of the UE I have.
They are labeled as trees C & D and there are two identical trees of each.
The light-grey C trees hold 15 parts each.
The light-grey D trees hold 37 parts each.
There are two small decal sheets in the kit. One sheet (the larger of the two) is almost a direct copy of the decals in the UE kit by Mirage. It is only missing the German white cross. It has the stencils for the rockets and the crates like the UE kit did.
A second, smaller decal sheet has black German crosses on it - that they want you to use - and 15th Panzer Division markings in white and black and some Afrika Korps palm tree and swastika marks that are excess to this version.
A second, smaller decal sheet has black German crosses on it - that they want you to use - and 15th Panzer Division markings in white and black and some Afrika Korps palm tree and swastika marks that are excess to this version.
The road wheels and bogies removed from the tree and ready to assemble.
The leaf spring brackets.
Intake and tools.
Loose trees from Tree 1.
I have only assembled the hull tub and top and the drive sprockets so far.
These are two of the built crates that hold the rockets.
The rockets and two road wheels.
A shovel and Notek light.
The only interior parts provided are two seat bottoms in the driver's compartment. Hardly the detail needed there if you wanted to do an interior!
I think that this kit and the companion kit of the UE with the same rockets on it will look neat beside each other. I really like special purpose vehicles.
I'm not really looking forward to assembling those teensy weensy individual tracks. Otherwise this kit is highly recommended.
I think that this kit and the companion kit of the UE with the same rockets on it will look neat beside each other. I really like special purpose vehicles.
I'm not really looking forward to assembling those teensy weensy individual tracks. Otherwise this kit is highly recommended.
I want to, again, thank my friend Mitsu in Japan for trading this kit to me.